Friday, May 6, 2011

Adding fiber to concrete

Fibers are sometimes added to concrete mix. Why is this done?

Concrete is a mixture of aggregate (rocks), sand , Portland cement, and water. Water combines with cement to form hydration products, which glue the mix together.

Upon initial set, there is a volume shrinkage of the cement paste. This small shrinkage may result in micro-cracks; tiny little flaws on the surface of the curing concrete. These cracks occur because wet cement paste has a low tensile strength, and cannot resist the small shrinkage from the initial cure.

Once cement has cured, it forms a brittle material. When any brittle material cracks, it always begins cracking at a small surface flaw, such as those produced on initial set, due to weak cement paste shrinkage. If these micro-cracks can be eliminated, a much stronger and longer-lived concrete is produced.

Micro fibers have a tendril-like structure, where tiny little spirals come out of a larger fiber (commonly polypropylene). When properly mixed, this type of fiber provides anchorage and locking into a wet cement paste. It will provide the necessary tensile strength for the wet cement paste to resist micro-cracking from shrinkage on initial set.  This results in a much stronger and tougher concrete.


Fiber added to concrete mix reduces the workability of the wet concrete to a small degree. It can be difficult to float a surface due to the fibers.

The specifications for fiber concrete show no increase in tensile strength, but those who really know concrete realize that these microfibers provide an actual slight increase in tensile strength of concrete, and also increase its toughness (resistance to crack propagation). Fibered concrete is a little tougher and has more flexural rigidity.

Fiber added to concrete mix makes a better concrete.

11 comments:

  1. This research investigated the fresh concrete properties, mechanical properties and early shrinkage crack of hydrophilic polyvinyl alcohol(PVA) fiber reinforced concrete with fiber volume fraction and fiber length. The effects of differing fiber volume fraction(0.05%, 0.07%, 0.1%, 0.15%) and fiber length(4 mm, 6 mm, 8 mm, 12 mm) were studied. Test was conducted with slump, air content, compressive strength, flexural performance, and plastic shrinkage crack of PVA fiber reinforced concrete. Test results indicated that PVA fiber reinforcement showed an ability to reduce the total crack area, maximum crack width. Also, the mechanical properties test showed that the addition of PVA fiber improved mechanical performance. Specially, optimum PVA fiber reinforced concrete were obtained using 4mm or 6mm fiber length and 0.07% fiber volume fraction.

    Mechanical and Early Shrinkage Crack of Hydrophilic PVA Fiber Reinforced Concrete with Fiber Volume Fraction and Fiber Length.

    Available from: http://www.researchgate.net/publication/263362173_Mechanical_and_Early_Shrinkage_Crack_of_Hydrophilic_PVA_Fiber_Reinforced_Concrete_with_Fiber_Volume_Fraction_and_Fiber_Length [accessed Oct 5, 2015].

    ReplyDelete
  2. Steel Fibers in concrete evenly distributes in concrete mixture to provide improved mechanical properties of concrete such as flexural strength, shear strength, fatigue endurance, impact resistance and ductility.

    ReplyDelete
  3. To provide utltimate strength and resistance to the cement steel fibre reinforced concrete has been used.

    ReplyDelete
  4. Your article was very impressive. Steel fibre is cold drawn steel wire fiber crafted from high quality. For More Detail Visit Here : Steel fibre

    ReplyDelete
  5. Fibre in concrete is used to control plastic shrinkage cracking and drying shrinkage cracking.

    ReplyDelete
  6. It’s really great information for becoming a better Blogger. Keep sharing, Thanks. For more details to visit Steel fibers for concrete.

    ReplyDelete
  7. I read your post 'Adding fiber to concrete', Thanks, for such a great post. I have tried and found it really helpful. For more details to visit steel fibres for concrete.

    ReplyDelete
  8. I am all that much satisfied with the substance you have specified. I needed to thank you for this extraordinary article. SAKURAI plastic mols release agent

    ReplyDelete
  9. This is such a great resource that you are providing and you give it away for free. Little Rock Brick or Stone Step Installation

    ReplyDelete
  10. Wonderful blog!!! the article which you have shared is informative for us... thanks for it...

    Steel Fiber Reinforced Concrete

    ReplyDelete
  11. I want new people to learn from your website. The blog and web design are classic. Negan Jacket

    ReplyDelete